The manual says to scroll through the menu via the switch on the turn signal stalk, then select with the BC button at the end. Works fine, except my only options are display brightness, check control, time and date. No service menu option/icon as shown in the manual. What am I doing wrong? I know it's there because I remember the salesperson showing me the oil level readout.
Also, how do you switch day/month to month/day? I was able to change format with time but can't see how to re date.
|
| Reply » How to access Service Info on display? |
The engine must be running to access the rest.  The date is changed with the mm/tt setting. Take your time and read the manual.
|
| Reply » How to access Service Info on display? |
Quote: | The engine must be running to access the rest. The date is changed with the mm/tt setting. Take your time and read the manual. | Thanks re the engine must be running - makes sense!!
As to the date, I was looking right at the manual - that's how I figured out the time format change. I wasn't so lucky re date. I'll try again but I really don't get it.
|
| Reply » How to access Service Info on display? |
It is under the same settings of F/C, 12h/24h, etc...
|
| Reply » How to access Service Info on display? |
Quote: | It is under the same settings of F/C, 12h/24h, etc... | I did the time format change while in the time function itself. I didn't see the general format fuction you just listed when I was scrolling with the turn stalk switch. How do I access it?
|
| Reply » How to access Service Info on display? |
Quote: | I did the time format change while in the time function itself. I didn't see the general format fuction you just listed when I was scrolling with the turn stalk switch. How do I access it? | It's in the date function under SET IIRC. Scroll button 1 (up/down) on the stalk under SET. Button 2 to set date format(end of stalk). Button 1 again to scroll format mm/tt or tt/mm. tt =dd. Button 2 to accept.
|
Page 1 of 2 |
Menu
How to access Service Info on display?