Engine Service Soon light came on | Forums BMWauto.net || BMW AUTO - cars, motorcycles, tuning, ads, photos  
 

  Home    |    BMW website    |    BMW History    |    Contact us    |
  FORUMSbmwauto.net BMW Disscussion forums || www.bmwauto.net/forums
   Menu
    General BMW
    BMW 3-Series
    BMW 5-Series
   BMW Z-Series
    BMW European Delivery
    BMW FORUMS - home page

  What's Going On?
There are 43 guests on-line

  BMW Forums » BMW discussion forums » BMW Z-Series
  Engine Service Soon light came on

 Engine Service Soon light came on



on my 01 Mroadster after coolant was drained and refilled. Autozone scanner did not work it kept getting "Link Error". Maybe coolant got onto the OS??? Any suggestions??? TIA
   Reply » Engine Service Soon light came on

Wish I could help, but I have a similar problem with my 2000 M coupe. I had a CEL telling me my 02 sensor 1 - 3 pre-cat was bad. Changed all sensors now I have a CEL telling me 1 - 3 post cat is bad When I reset the light doesn't go out, however when I start the car and drive the light is off...until I turn off the car and restart it again

   Reply » Engine Service Soon light came on

Quote:
I had a CEL telling me my 02 sensor 1 - 3 pre-cat was bad. Changed all sensors now I have a CEL telling me 1 - 3 post cat is bad
Did you replace with BMW sensors?

   Reply » Engine Service Soon light came on

Hey Ron, not to jack this thread but i got my peak tool today, there site shows a r5/srs-16 for 2001-2003 that is what i ordered, I got a r5/srs per reciept says 93-00 models?
is this the right one do you think, i do have the round connector under the hood and tool is round

   Reply » Engine Service Soon light came on

Quote:
Hey Ron, not to jack this thread but i got my peak tool today, there site shows a r5/srs-16 for 2001-2003 that is what i ordered, I got a r5/srs per reciept says 93-00 models?
is this the right one do you think, i do have the round connector under the hood and tool is round
I have the same one. It works on my car (used it last night since I had the drivers air bag out) but comes up with the flashing E (communication error) when you do a reset. I worked with Dan Peake on this but he never followed through.

   Reply » Engine Service Soon light came on

Quote:
Did you replace with BMW sensors?
Well, I have Bosch in the front, since Bosch was out of stock, and Siemens in the back (from Pelican) which were the same as the ones I took out.
My airbag light is also on. I tried to reset and got the "E" also, and Dan from Peake sent me a website to go to for add'l instructions, but that didn't help either.

http://www.peakeresearch.com/srstech.htm

Lights are still shining! However, the car drives just fine.


Page 1 of 2

1 2



  BMW Forums » BMW discussion forums » BMW Z-Series

 

Forums BMWauto.net (c) 2001-2007